Eagle Mountain HVAC Company serves homeowners, property managers, and businesses across Eagle Mountain and the wider Utah County area with the full range of residential and commercial heating and cooling work. Whether the call is about a furnace that quit overnight, an AC that stopped keeping up with a July afternoon, or a full system that has reached the end of its run, the job gets scoped on the phone before anything is scheduled. HVAC work sized and installed the way the manual calls for is the standard here, not the exception. Furnace fixed. AC humming. Home comfortable again.
Every home's heating and cooling setup tells a different story, and the work reflects that. Some calls are straightforward: a capacitor that failed, a filter so clogged the blower gave up, a thermostat that lost communication with the air handler. Others take more digging: a heat pump that heats fine but won't cool, a furnace that fires and then shuts off before the house warms up, a new build that needs a complete system from the ground up.
We handle all of it. AC repair and seasonal service, furnace repair and replacement, heat pump work across both heating and cooling seasons, full HVAC system installation, thermostat and smart control setup, ductwork repair and sealing, indoor air quality, and seasonal maintenance for both residential and commercial customers. If it conditions the air in a building, it falls inside what we do. Give us a call and we'll get the comfort back.
When an air conditioner stops cooling, the diagnosis usually starts at a few known points: refrigerant charge, condenser and evaporator coil condition, airflow through the system, and whether the thermostat is communicating correctly with the equipment. A warm house and a unit that runs continuously often point in different directions, and sorting out which one applies matters before any parts are ordered or any work is quoted.
A diagnostic visit covers the full picture. The technician who comes out checks the coil condition, measures airflow, looks at the refrigerant side, and confirms the thermostat is reading and responding the way it should. The thermostat confirmed as communicating before sign-off is part of every AC service call, not an afterthought. From there, the findings are explained and the repair is priced before anything moves forward. We'll get the fault identified and the work priced.
A system's age says a lot about which repair makes sense, and furnace calls make that calculation concrete. A furnace blowing cold air, a furnace that fires and then shuts off on limit, or a unit that simply won't start all point to different causes. The heat exchanger, the igniter, the flame sensor, the filter condition, and the age of the unit together tell you whether a repair is the right move or whether replacement is the better answer for the long run.
A furnace service call covers the components that matter: heat exchanger condition, igniter and flame sensor function, filter inspection, and a check of the controls. Where the age of the equipment and the cost of the repair are close, we walk through both options so the decision is yours to make with the full picture in front of you. We'll go through what the service covers before it is booked.
Heat pumps handle both seasons, which means a heat pump diagnostic is different from a standard AC or furnace call. A unit that heats in January but won't cool in July, or one that runs constantly without reaching the set temperature, can point to refrigerant issues, reversing valve problems, or defrost cycle faults, depending on the season and the symptom. Getting that right takes a different checklist than a single-season system.
Ductless mini-splits carry their own set of considerations. A wall-mounted head that drips, a zone that won't respond to the remote, or an outdoor unit throwing a fault code are all jobs we handle. Mini-split installation, whether for a single room addition or a multi-zone setup, is also on the list. We'll take the details and get it scheduled.
Noticing uneven temperatures or a spike in energy bills? An aging system that can no longer hold the set temperature, or one that has failed outright, makes the replacement conversation unavoidable. What that conversation should cover is load calculation: the square footage, the insulation levels, the window exposure, and the duct layout all factor into what size unit the house actually needs.
Equipment that is oversized short-cycles and wears out faster. Equipment that is undersized runs constantly and never catches up. HVAC work sized and installed the way the manual calls for is the standard we hold to, because a system that fits the building is the one that performs the way the manufacturer's specs say it should. The replacement visit covers the sizing work, the equipment selection, and the installation itself. The scope and the price are confirmed before the job starts. We'll go through what the service covers before it is booked.
A thermostat that is not reading correctly, not communicating with the air handler, or simply too old to program effectively is a straightforward fix that has an outsized effect on comfort and energy use. Smart thermostat installation, programmable thermostat replacement, and thermostat wiring corrections are all jobs we handle. The thermostat confirmed as communicating before sign-off is part of every installation.
Leaking ducts are one of the more common causes of uneven temperatures and higher energy bills, and they often go unnoticed because the problem shows up at the vents rather than at the equipment. Ductwork checked when the symptoms point that way is part of how we approach a call that does not have an obvious equipment cause. Duct sealing and duct repair are scheduled the same way as any other service call: scope and price confirmed before work begins.
Whole-home air filtration, UV air purifiers, and HEPA-rated filtration systems are all options worth discussing if the air inside feels stale, dusty, or is affecting anyone with respiratory sensitivities. The right setup depends on the existing system and what the household needs. We'll take the details and get it scheduled.
A spring AC tune-up and a fall furnace tune-up are the two calls that catch most problems before they become failures. On the cooling side, a tune-up covers coil cleaning, refrigerant charge check, capacitor condition, and airflow. On the heating side, it covers heat exchanger inspection, igniter condition, filter swap, and burner operation. Readings shared at the end of a maintenance visit are standard, so there is a clear record of where the system stands.
Maintenance is open to both residential and commercial customers. A commercial property with multiple rooftop units or a split system serving an office space gets the same thorough check as a single-family home. Scheduling a tune-up before the season changes is the most straightforward way to avoid a no-heat or no-cool call at the worst possible time.
Eagle Mountain sits at elevation and sees real winters. Overnight lows that drop well below freezing from November through March put sustained demand on furnaces and heat pumps in a way that milder climates do not. A heat pump that handles a 20-degree night in Lehi is working harder than the same unit would in a warmer region, and sizing for that load matters.
Summers bring the other side of the equation. July and August afternoons in Utah County push temperatures high enough that an undersized or poorly maintained AC cannot keep pace. A system that was adequate three summers ago may not be adequate now if the refrigerant charge has drifted or the coils have not been cleaned. Short-season AC service, where the window between late spring and early fall is the only time the system runs hard, means that deferred maintenance shows up fast. The work here is calibrated to both ends of that range.
Property managers have a different problem from homeowners, and the service call reflects that. A rooftop unit that fails on a weekday morning affects tenants, customers, or staff, and the window for getting it back online is shorter than it would be in a residence. Commercial HVAC repair, commercial heat pump service, and heating and cooling work for office spaces, retail properties, and multi-unit buildings are all part of what we do.
Scheduling for commercial properties takes into account that some spaces cannot be taken offline during business hours and that some equipment requires access coordination. What the thermostat is telling you is a good place to start. Call with the property type, the equipment on site, and what the system is doing, and we will scope the job from there. We'll get the fault identified and the work priced.
A furnace that quit at midnight or an AC that stopped working on the hottest afternoon of the year is not a call that can wait until next week. When the system is down, the job is scoped on the call, availability is confirmed, and the price is set out before anyone is dispatched. We take emergency calls every day from 5:30 AM to 10:00 PM, and the process is the same whether the call comes in at 6 AM or 9 PM.
No heat and no cooling are the two situations where getting the details right on the phone matters most, because the wrong part ordered or the wrong diagnosis assumed costs time the household does not have. Code-compliant work. Clear diagnosis. Pricing set out up front.
Dealing with a furnace that won't keep up or an AC that can't cool? The first step is a call, not a visit. Pricing is confirmed on the phone before the visit is scheduled, and the scope of the work is walked through before anything is booked. That means the customer knows what the service call covers, what the diagnostic involves, and what the repair or installation is going to cost before the appointment is set.
There is no reason to wait until the technician is at the door to ask what the work costs. Ask on the call, and the answer is a straight one. The price is confirmed before we schedule, and what it covers is explained up front. We'll go through what the service covers before it is booked.
Eagle Mountain is the home base, and the service area runs across Utah County and into the communities nearby. We work in Saratoga Springs, Lehi, Cedar Hills, American Fork, Highland, and Herriman, along with the surrounding area. If the property is in Utah County or close to it, call and ask what the schedule allows.
Residential and commercial customers across the area get the same service: scope confirmed on the call, price set before the visit, and the work carried out to the standards that apply here.
When you call, you reach someone who knows the trade and can ask the right questions about what the system is doing. That person goes through the symptom with you, scopes what the visit should cover, and gives you a price before anything is scheduled. The call is the starting point for getting the job set up correctly.
Eagle Mountain's elevation and dry winters put sustained demand on heating systems from late fall through early spring, and summers are hot enough that an undersized or poorly maintained AC falls behind quickly. We size equipment to the actual load the building presents, because a system that fits the house performs the way the specs say it should across both seasons. That approach matters more here than it would in a milder region.
A furnace blowing cold air can trace to a failed igniter, a tripped limit switch, a clogged filter, or a heat exchanger issue, and the right fix depends on which one the diagnostic turns up. A heat pump that won't heat in January points to a different checklist than a central AC that won't cool in July, even though both are refrigerant-based systems. Getting the diagnosis right before any parts are ordered is what keeps the repair from becoming two visits instead of one.
Before the job is considered finished, the system is tested under operating conditions and the thermostat is confirmed as communicating correctly with the equipment. On a maintenance visit, readings are shared so there is a clear record of where the system stands. The work is not signed off until the system is running the way it should.
If a repair requires a part that is not immediately available, we go through the situation with you on the same visit: what the fault is, what is needed to fix it, and what the timeline looks like. In some cases a temporary measure can keep the system running while the part is sourced. We confirm the next step before leaving so you are not left without a plan.
If the system is not performing correctly after a visit, call (385) 263-3965 and describe what you are seeing.
We go through the situation, determine whether it is related to the work that was done, and get back out to address it. The goal is a system that works the way it should, and a callback is treated as part of getting there.
The person who comes out works around the equipment and the access points the job requires, and takes care not to damage flooring, walls, or finishes in the process. If the job involves working in a finished space, that is factored into how the work is approached. Any questions about what the visit involves can be asked on the call before it is booked.
The technician who comes out will confirm what the visit covers, ask any follow-up questions about the symptom, and get access to the equipment. The diagnostic or service work proceeds from there, and findings are explained before any repair is quoted or started. Nothing moves forward without your approval on the scope and the price.
Yes. Older systems often carry faults that have been building over time, and newer systems can have installation or configuration issues that show up early. The approach is the same either way: diagnose the fault, explain the findings, and go through the repair or replacement options before any work is done. We cover the full range of equipment ages and configurations across Eagle Mountain and Utah County.
Eagle Mountain HVAC Company handles the full range of heating and cooling work for homes and businesses across Eagle Mountain and Utah County, from a furnace repair on a cold January morning to a full AC replacement before summer gets underway.
Call (385) 263-3965 to get a quote, confirm availability, or ask what a service call covers.
The scope and the price are settled on the call before anything is scheduled. Furnace fixed. AC humming. Home comfortable again.
(385) 263-3965